Minggu, 15 Mei 2011

How to Replace the Rotor in a Toyota Tundra

How to Replace the Rotor in a Toyota Tundra

The Toyota Tundra utilizes brake discs, also known as rotors, in combination with a caliper and brake pad assembly to bring your vehicle to a stop. If the rotors get warped or worn down, it can cause your Tundra to shudder and pulse when you hit the brakes. It's fairly easy to swap the rotors yourself and keep some extra money in your pocket.

Difficulty:
Moderate

Instructions

    • 1

      Jack up your Toyota Tundra. Block the wheels that you aren't working on to keep your Tundra from rolling while you work. Disconnect the negative battery cable. Remove the first tire and wheel assembly.

    • 2

      Remove the brake hose from the caliper and then quickly plug the end of the hose to prevent spillage. Next, remove the two caliper mounting bolts. This allows you to then pull the caliper assembly off of the old rotor.

    • 3

      Clean the area around the hub with a damp cloth to remove any dirt or corrosion. Install the new rotor onto the hub.

    • 4

      Lubricate the caliper slides and bolts with lithium grease and then install the caliper and tighten the bolts. Torque the caliper bolts to 90 ft. lbs. (123 Nm).

    • 5

      Reconnect the brake hose to the caliper and torque to 11 ft. lbs. (15 Nm). Refill the brake fluid and then bleed the brakes. Install the wheel assembly and tire.

    • 6

      Repeat this process for each additional rotor. When you're finished, lower your vehicle, double check the brake fluid level and reconnect the negative battery cable.

    • 7

      Pump the brakes until you get a firm pedal and then be sure to road test your Toyota Tundra to make sure that the installation was successful.

Tidak ada komentar:

Posting Komentar